Table of Contents
Advertisement
Turn the head until the 'D' matches the one on
the burner base. Turn the head over and place it
on the burner base. To fit the small inner burner,
find the larger electrode notch in the burner rim.
Line this up with the white ignition electrode and
place the inner burner on the large base ring.
A
electrode notch
Now fit the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS
AS THESE WILL DAMAGE THE SURFACE.
Handygrill
The pan and grid should be washed in hot soapy
water. After grilling meats or any foods that soil,
leave to soak for a few minutes in the sink
immediately after use. Stubborn particles may be
removed from the grid by using a nylon brush.
B
ignition electrode
Control Panel and Doors
Avoid using any abrasive cleaners including
cream cleaners, e.g. Cif, on brushed Stainless
Steel surfaces. For best results use a liquid
detergent e.g. Domestos Multi Surface Cleaner.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water. Wipe with a clean dampened
cloth then polish with a dry cloth. The oven doors
should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
Ovens
The ovens have removable panels that have been
coated with a special enamel that partly cleans
itself. This does not stop all marks on the lining,
but helps to reduce the amount of manual
cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot
soapy water. The panels should then be
dried and replaced and the oven heated at
200°C for about one hour. This will ensure
the Cook & Clean panels are working
effectively.
Don't use steel wool (Brillo) or any other
materials that will scratch the surface. Don't use
oven cleaning pads.
Removing the Oven Linings
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves first.
The right hand fanned oven has a removable
oven roof - slide the roof liner forward and
remove.
The side panels of either oven can be removed.
Each side of the oven is fixed with four fixing
screws. You don't have to remove the screws to
remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then
pull them forwards.
19
Advertisement
Table of Contents
