Table of Contents
Advertisement
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
7
To Remove an Oven element Thermal
Cut-Out.
Disconnect the appliance from the electricity
supply. Pull the cooker forward to gain access to
the cover box. Undo the cover screws and lift clear.
The cutout is located on the earth plate beside the
oven element connections. Disconnect the cutout
wiring. Undo the fixings that secure the cutout to
the earth plate and remove. Fit replacement control
and re-assemble in reverse order.
8
To Remove a Hotplate Tap
Remove the hotplate – see 2. Unplug the FSD lead
from the rear of the tap. Undo compression fitting
at the rear of the tap. Remove the fixings that
secure the tap to the gas rail. Disconnect the
ignition switch wiring. Remove the tap. Remove
and discard the gasket seal. Fit new gasket seal to
replacement tap. Re-assemble in reverse order.
Check the appliance is gas sound. Check hotplate
ignition.
9
To Change an Ignition Switch
Change the gas tap - see 7.
10 To Remove a Hotplate Burner Injector
Remove the hotplate - see 2. Remove the injector
directly from the burner body. Fit the appropriate
injector. Re-assemble in reverse order. Check the
appliance is gas sound.
11 To Remove a Hotplate Burner Spark
Electrode
Remove the pan supports, burner heads and caps.
Remove the screw holding the electrode to the
burner body. Lift up the electrode and disconnect
the lead.
Note
Take care to prevent the ignition wire from falling
back through the clearance hole.
Fit the lead to the new electrode and reassemble in
reverse order and check correct burner ignition.
12 To Remove an Oven Door
Open the oven door. Support the door and remove
the two screws that secure the upper hinge to the
front frame of the unit. Remove the door from the
lower hinge by lifting slightly and moving it
outward. Re-assemble in reverse order.
13 To Remove the Oven Outer Door Panel
Open the oven door. Remove the socket headed
screws at the sides of the door. Remove the outer
door panel. Remove the handle and fit to the new
door panel. Fit the replacement panel to the oven
inner door. Re-assemble in reverse order.
SERVICING - WARNING
14 To Remove the Door Latch
Remove the oven outer door panel – see 12.
Remove the fixings that secure the latch assembly
to the inner door panel. Fit the replacement catch
and re-assemble in reverse order. Check correct
operation of door.
15 To Remove the Oven Door Seal
Open the oven door. The seal is held in place by
small hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that
hook is released. Proceed to the next hook and
release it in a similar way, and so on. Use force if
the hooks are stiff, as the old seal will be discarded.
When fitting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner
holes of the door, and proceed round the door
snapping in each hook in turn.
16 To Adjust the Oven Door Catch Keeper
Open the oven door and slacken the locknut at the
keeper base. Adjust the keeper inward or outward
as required, until the desired door operation is
obtained. Re-tighten the locknut.
17 To Remove the Hotplate Spark
Generator
Disconnect the appliance from the electricity
supply. Pull the cooker forward to access the cover
boxes at the appliance rear. Remove the fixings that
secure the cover and lift it clear. Undo the terminal
connections noting their positions. Undo the fixings
that secure the spark generator and remove the
device.
35
Advertisement
Table of Contents
