Table of Contents
Advertisement
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Servicing
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS. TURN OFF THE GAS SUPPLY
Check the appliance is gas sound after completion
of service. When checking for gas leaks do not use
washing up liquid - this can corrode. Use a product
specifically manufactured for leak detection.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from the electricity supply before
commencing servicing, particularly before
removing any of the following: - control panel, side
panels, hotplate tray or any electrical components
or covers.
Before electrical re-connection, check that the
appliance is electrically safe.
Note - References to LH and RH oven apply as
viewed from the front.
1
To Remove the Control Panel
Disconnect the appliance from the electricity
supply. Remove the pan supports and control
knobs. Remove the 3 screws at the rear of the top
edge of the control panel.
Open the oven doors and remove the 2 fixing
screws, one at each end, underneath the control
panel. Lift the control panel, pull forward and
disconnect the wiring from the rear.
Replace in reverse order.
A Control panel top fixing screws
B Hotplate front fixing screws
C Hotplate back fixing screws
2
To Remove the Hotplate top
Disconnect the appliance from the electricity
supply. Pull cooker forward to gain access.
Remove the control panel see 1. Remove the
hotplate burner caps and tops. If there are screws
holding the hotplate burners to the hotplate,
remove them (not the spark electrode fixing
screws). Remove the 2 hexagon headed rear
SERVICING - WARNING
hotplate fixing screws and the 3 front hotplate
fixing screws. Lift the hotplate clear of the
appliance. Replace in reverse order.
3
To Remove an Outer Side Panel
Disconnect the appliance from the electricity
supply. Remove the control panel – see 1. Remove
the retaining screw on the upper front edge and the
two fixings on the rear or the side panel. Undo the
lower retaining screw situated below the edge at
the panel front corner. Remove the panel by pulling
it away from the unit.
4
To Remove an Oven Neon
Remove the control panel – see 1. Hold the lens in
position at front of the panel and from the rear pull
the body of the neon out of the front lens. Hold the
front lens in position and from the rear of the
control panel fit the new light to the lens. Replace
parts in reverse order. Ensure the replacement neon
functions correctly.
5
To Remove the Clock
Remove the control panel - see 1.
Pull off the timer control button(s). Remove the
timer/mounting bracket assembly from the facia by
removing the fixing screws. Remove the timer from
its mounting bracket by depressing the plastic lugs
on the timer case, at the same time pulling the unit
forward. Reassemble in reverse order. When
replacing leads refer to the wiring diagram. Check
operation of timer.
6
To Remove a Thermostat
Disconnect the appliance from the electricity
supply. Remove the hotplate – see 2. Open the
appropriate oven door and remove the oven
shelves.
RH oven
Remove the two fixings that secure the thermostat
phial cover. Unclip the thermostat phial from the
clips in the oven back panel.
LH oven
Remove the two screws holding the thermostat
phial to the oven fan cover at the rear of the oven.
Pull the unit forward to access the rear of the
cooker. Remove the both cover boxes by removing
the fixing screws and lifting clear. Feed the
thermostat capillary clear of the oven. Disconnect
the wires from the thermostat and undo the two
fixings that secure the control to the mounting
plate. Fit the replacement and re-assemble in
reverse order. Ensure that the phial is clipped to the
oven rear, positioned centrally between the clips.
Check that the thermostat functions correctly.
34
Advertisement
Table of Contents
