Simrad RS20 User Manual page 35

Flush installation
1.
Tape the installation template onto the chosen mounting location.
2.
Cut out the area marked by the solid dark line (the dashed line indicates the
total area that will be covered by the radio fascia after installation).
3.
Use a 2.5mm (3/32" ) drill bit to drill the 4 pilot holes.
4.
Remove the installation template.
5.
Fit the gasket to the radio.
6.
Slide the radio into the cavity.
7.
Using a Philips screwdriver, secure the radio using the supplied 3.5x20mm
self-tapping screws to the mounting location.
8.
Fit the bezel trim to cover the 4 mounting screws.
Install the hand mic bulkhead bracket
1.
Hold the hand mic bulkhead bracket at the chosen location and mark the
screw hole positions on the mounting surface.
¼ Note:
Ensure that the microphone curly cable will comfortably reach
this location BEFORE you drill.
2.
Use a 2.5mm (3/32" ) drill bit to drill the 2 pilot holes.
3.
Using a Philips screwdriver, secure the Mic mount using the supplied
3.5x20mm self-tapping screws to the mounting location.
4.
Hang the fist mic on the mount.
Installation | RS20 operator manual
| 35