Simrad RS20 User Manual page 3

during operation. Further, this transmitter must not be co-located or
operated in conjunction with any other antenna or transmitter.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
¼ Note:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a normal installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an output on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced technician for help.
A shielded cable must be used when connecting a peripheral to
the serial ports.
Innovation, Science and Economic
Development Canada Compliance
This equipment complies with ISEDC RF radiation exposure limits
set forth for an controlled environment. This transmitter must not
be co-located or operating in conjunction with any other antenna
or transmitter. This equipment should be installed and operated
with minimum distance 89cm between the radiator & your body.
ISEDC exposition aux radiations:
Cet équipement est conforme avec ISEDC les limites d'exposition
aux rayonnements définies pour contrôlé environnement.
Cet émetteur ne doit pas être co-localisés ou fonctionner en
| RS20 operator manual
| 3