modway MOD-5365 Quick Start Manual page 2

MODWAY
HEADBOARD
STEP 1:
Put the Headboard (1) upside down on a carpeted or padded area by two adults
Then insert the Low Posts (2) into the bottom of Headboard (1) and align pre-drilled Low Post (2) holes to the pre-
drilled Headboard (1) Holes according to your desired headboard height.
Attach each of Low Post (2) by using 2 piece of Flat Washer (B) and 2 pieces of Bolt (A) from the holes on the back
of Low Post (2) and Headboard (1). Tighten with Allen Wrench (C).
Back
Back
C
1
2
2
1
A
B
2
2
Ax4 Bx4 Cx1
Hardware & Tool required
STEP 2:
Carefully turn up the assembled Headboard (1) by two adults.
Assembly is completed. The headboard is ready to use now!
NOTE: Hardware may loosen over time. Periodically check that all connections are tight.
Customer Service 908-368-1025︱ ︱ ︱ ︱ www.modwayfurniture.com
Page 2 of 6