Table of Contents
Advertisement
Installation
5.6
Mounting the Camera
To eliminate IR reflection
1. Clean the bubble from dirt and finger prints.
2. Make sure the bubble has no scratches.
3. Avoid aiming the IR where there are nearby objects closer than the scene of interest which might
reflect back into the lens.
To mount the camera
1. Do one of the following:
·
For drilled wall or ceiling mounting:
a. Using the supplied template, mark with a pointed pencil the mounting surface through the
plate holes where the four screw holes need to be drilled.
Note:
Before marking and drilling the holes, ensure that the base plate alignment is oriented
correctly so that the required camera field of view can be achieved when the system is
assembled.
b. In the marked locations, drill each hole using a drill bit of a slightly smaller diameter than
the supplied screw anchors (molly-plug anchor). You want to achieve a snug insertion so
that the plug expansion holds firm after the screws are screwed in.
c. Fully insert the supplied anchors into drilled holes. You may need to tap them flush
with the wall using a hammer.
22
Drill Template
CM-6212 H1-I User and Installation Guide
October 17, 2017
Advertisement
Table of Contents
