Table of Contents
Advertisement
Concern
Potential Cause
Opening/Closing Of Doors/Drawers
Door(s) will
•
not close.
•
•
Drawers are
•
difficult to
move.
•
Running of Refrigerator
Compressor
•
does not run.
•
•
•
•
Refrigerator
•
seems to run
too much or
too long.
Digital Temperature Setting Display
Digital
•
temperature
displays
an error.
Water/Moisture/Frost Inside Refrigerator
Moisture
•
collects on
inside of
•
refrigerator
walls.
Water collects
•
on bottom
side of drawer
cover.
Door was closed too hard,
causing other door to
open slightly.
Refrigerator is not level. It
rocks on the floor when
moved slightly.
Refrigerator is touching a
wall or cabinet.
Food is touching shelf on top
of drawer.
Track that drawers slide on
is dirty.
Freezer control is set to "OF".
Refrigerator is in defrost
cycle.
Plug at electrical outlet
is disconnected.
House fuse blown or tripped
circuit breaker.
Power outage.
Your variable speed
compressor is designed to
run 100% of the time except
during the defrost cycle. At
times it will run faster, such as
after a defrost cycle.
Electronic control system
has detected a performance
problem.
Weather is hot and humid.
Flipper mullion
Vegetables contain and give
off moisture.
TROUBLESHOOTING
Common Solution
•
Close both doors gently.
•
Ensure floor is level and solid, and can
adequately support the refrigerator. Contact a
carpenter to correct a sagging or sloping floor.
•
Ensure floor is level and solid, and can
adequately support the refrigerator. Contact a
carpenter to correct a sagging or sloping floor.
•
Remove top layer of items in drawer.
•
Ensure drawer is properly installed on track.
•
Clean drawer, rollers, and track. See Care &
Cleaning.
•
Set freezer control.
•
This is normal for a fully automatic defrost
refrigerator. The defrost cycle occurs
periodically, lasting about 30 minutes.
•
Ensure plug is tightly pushed into outlet.
•
Check/replace fuse with a 15 amp time-
delay fuse. Reset circuit breaker.
•
Check house lights. Call local electric company.
•
It is normal for the compressor to run
continuously except during defrost mode.
•
Call your Electrolux service representative,
who can interpret any messages or number
codes flashing on the digital displays.
•
The rate of frost buildup and internal
sweating increases.
Adjust flipper mullion. (See To adjust the
•
flipper mullion in the Installation section.)
•
It is not unusual to have moisture on the
bottom side of the cover. Move humidity
control (some models) to lower setting.
45
Advertisement
Table of Contents
