Yamaha FJR13AY 2009 Service Manual page 672

YCC-S (Yamaha Chip Controlled-Shift) SYSTEM (FJR13AE only)
Diagnos-
tic code Item
No.
Sh_ _65 Gear position setting Sh_ _65
Data displayed on
meter (reference
value)
The gear position can be set in this mode.
1. Make sure that the transmission is in
2. Push the start switch.
3. Shift the transmission into 1st gear us-
4. Push the start switch.
5. Repeat steps 3 and 4 for each gear up
6. Shift the transmission into 4th gear us-
7. Push the start switch.
8. Repeat steps 6 and 7 for each gear
9. Shift the transmission into neutral.
10.After the above procedure is complet-
11.Operate the brake lever or brake pedal
8-189
Checking method
neutral.
If the gear position sensor output signal
is correct for the neutral position, the
hand shift select indicator light will
come on for 0.5 second.
ing the hand shift lever switch (shift up),
and then rotate the rear wheel at least
1/2 turn by hand to ensure that the dog
completely engages the 1st gear.
If the gear position sensor output signal
is correct for the 1st gear position, the
hand shift select indicator light will
come on for 0.5 second.
to the 5th gear and make sure that the
hand shift select indicator light comes
on for 0.5 second each time the start
switch is pushed.
ing the hand shift lever switch (shift
down), and then rotate the rear wheel at
least 1/2 turn by hand to ensure that the
dog completely engages the 4th gear.
If the gear position sensor output signal
is correct for the 4th gear position, the
hand shift select indicator light will
come on for 0.5 second.
down to the 1st gear and make sure
that the hand shift select indicator light
comes on for 0.5 second each time the
start switch is pushed.
ed, all of the gear position data is tem-
porarily stored and ready to be written
on EEPROM.
to write the data on EEPROM.
If all of the data has been written suc-
cessfully on EEPROM, the hand shift
select indicator light will come on for 2
seconds.
If the data is not written successfully,
the hand shift select indicator light will
flash.