Yamaha FJR13AY 2009 Service Manual page 671

YCC-S (Yamaha Chip Controlled-Shift) SYSTEM (FJR13AE only)
Diagnos-
tic code Item
No.
Sh_ _64 Shift actuator opera-
tion
TIP
The checking meth-
od for the diagnostic
code (Sh_ _64) can-
not be performed
when any of the fol-
lowing fault codes
are detected.
Sh_ _11, Sh_ _12,
Sh_ _14, Sh_ _15,
Sh_ 16, Sh_ _18,
Sh_ _19, Sh_ _25,
Sh_ _37, and Sh_
_51
Data displayed on
meter (reference
value)
Sh_ _64 The shift actuator can be operated in this
mode.
1. Make sure that the transmission is in
2. Set the engine stop switch to "
3. The MCU (motor control unit) detects
4. Set the engine stop switch to "
5. The MCU (motor control unit) detects
8-188
Checking method
neutral.
operate the hand shift lever switch (shift
up) simultaneously. The MCU (motor
control unit) operates the shift actuator
once.
The shift actuator is operated once
each time two switches are operated.
the signal from the shift actuator sensor.
If the signal received after upshifting is
correct, the hand shift select indicator
light will come on.
If the signal received after upshifting in
incorrect, the hand shift select indicator
light will flash.
operate the hand shift lever switch (shift
down) simultaneously. The MCU (motor
control unit) operates the shift actuator
once.
The shift actuator is operated once
each time two switches are operated.
the signal from the shift actuator sensor.
If the signal received after downshifting
is correct, the hand shift select indicator
light will come on.
If the signal received after downshifting
is incorrect, the hand shift select indica-
tor light will flash.
" and
" and