basic recording
SEARCHING QUICKLY FOR A DESIRED SCENE (SETTING THE ZERO MEMORY)
(VP-D392( i )/D395i only)
•
The zero memory function works in both Camera and Player modes. ➥page 18
•
You can mark a point on a tape that you want to return to following playback.
1. Set the Select switch to TAPE. (VP-D395i only)
2. Press the MODE button to set Camera (
3. Press the ZERO MEMORY button on the remote control before the recording or
during playback at the point where you wish to return.
•
The time code is changed to a tape counter that is set to zero memory with
the zero memory (
•
If you want to cancel the zero memory function, press the ZERO MEMORY
button again.
4. Finding the zero position.
•
When you have fi nished playback, fast forward or rewind the tape in stop mode.
The tape stops automatically when it reaches the zero position.
•
When you have fi nished recording, press the MODE button to set Player (
and press the
(REW) button.
The tape stops automatically when it reaches the zero position.
5. The tape counter with the zero memory (
display and the tape counter is changed to the time code.
•
In the following situations, zero memory mode may be cancelled
automatically:
- At the end of the section marked with the zero memory function.
- When the tape is ejected.
- When you remove the battery pack or power supply.
•
The zero memory may not function correctly where there is a break between
recordings on the tape.
•
The zero memory function is available only using the remote control.
38_ English
All manuals and user guides at all-guides.com
) or Player (
0:00:00 ) indicator displayed.
) indicator disappears from the
).
)
MODE
CARD
TAPE
(VP-D395i only)
BATT .
STBY
STBY
SP
0:00:30
0:00:00
16:9 Wide
16:9 Wide
10Sec
10Sec
60min
60min
16Bit
16BIt
S
C.Nite 1/30
C.Nite 1/30