Applying The Rtlc40 And Fastrack Scale System - Renishaw QUANTiC RTLC40 Installation Manual

Applying the RTLC40 and FASTRACK scale system

1. Thoroughly clean and degrease the substrate and allow
to dry. For locating the FASTRACK carrier, a ledge,
separate straight edge(s) or dowels can be used.
2. Check the alignment of the ledge / separate
straight edge(s) with respect to axis of motion
(see 'RTLC40 / FASTRACK system installation
drawing' on page 12).
3. Before sticking the FASTRACK carrier to the substrate bend
the centre section upwards slightly using a small pair of pliers.
4. Remove the backing liner and stick the FASTRACK
carrierto the substrate, locating it against a
ledge / separate straight edge(s) or dowels. Ensure
complete adhesion to the substrate by applying firm
finger pressure along the length of the FASTRACK
from the centre outwards towards each end using a
lint-free cloth.
NOTE: Allow the FASTRACK a minimum
of 20 minutes to adhere before removing
the centre section.
16 QUANTiC RTLC40 /FASTRACK
™ ™
incremental linear encoder system
5. Engage the centre section removal tool and, with a consistent forward pressure, remove the
centre section of the FASTRACK carrier.
If the ledge method or similar is used then the appropriate side panel on the removal tool will
need to be removed as shown below.
IMPORTANT: Wear suitable protective gloves whilst carrying out this procedure to avoid risk of cuts.
Side panels
Ledge