Establishing An Interface Through The Cmm - Lenovo Flex System Fabric CN4093 Installation Manual

Establishing an Interface Through the CMM

1. Log on to the CMM Command‐Line Interface (CLI) as described in the CMM
documentation. If necessary, obtain the IP address of the CMM from your system
administrator.
2. Set the environment to the bay where you installed the switch:
3. Execute the ifconfig command to configure the IP parameters you wish to use
for remote switch management. For example,
4. You should now be able to ping the switch from the CMM using this address:
© Copyright Lenovo 2017
For remote management functions, the switch requires a TCP/IP interface. This can
be configured through the CMM as follows:
Note: The default User ID for the CMM is USERID, and the default password
is PASSW0RD (where the sixth character is the number zero, not the letter
O). The User ID and password fields are case‐sensitive.
system> env -T system:switch[1]
ifconfig -i 192.168.70.1 -s 255.255.255.0 -g 192.168.70.100
where the -i parameter is the IPv4 address, -s is the subnet mask, and -g is the
default gateway.
system:switch[1]> ping -i 192.168.70.1
Reply from 192.168.70.1: bytes=64 time=0.198ms
Reply from 192.168.70.1: bytes=64 time=0.213ms
Reply from 192.168.70.1: bytes=64 time=0.228ms
Reply from 192.168.70.1: bytes=64 time=0.168ms
One the switch management address is configured, you can use it to establish a
Secure Shell (SSH)/Telnet session or Web session (HTTPS/HTTP) .
Note: SSH and HTTPs are enabled by default. Telnet and HTTP can be enabled
once you have initially logged into the switch.
The Web interface application and the SSHv2/Telnet client software provide
different ways to access the same internal‐switching firmware and configure it.
If your system application requires that you use the Web interface application, see
"Accessing the Switch Through the Browser‐Based Interface" on page
additional information.
If your system application requires that you use the SSHv2/Telnet client software,
see "Accessing the Switch Through the SSHv2/Telnet Interface" on page
additional information.
43 for
Chapter 3: Configuring the CN4093
41 for
39