Lenovo Flex System Fabric CN4093 Installation Manual page 28

Removing an SFP+ Module
1.
2.
3. Remove the fiber optic cable from the module that you want to replace. For more
4. Unlock the SFP+ module by pulling the wire tab straight out, as shown in the
5. Grasp the wire tab on the module and pull it out of the switch port.
6. Replace the protective caps on the module and the switch SFP+ port.
7. Place the module into a static‐protective package.
28
CN4093 Installation Guide
To remove the SFP+ module, complete the following steps.
Read the safety information that begins on page 5 and "Installation Guidelines" on
page 18.
Read the information in "Handling Transceiver Modules" on page
information about removing the cable, see "Disconnecting a Fiber Optic Cable" on
page 27.
Attention: To avoid damage to the cable or the SFP+ module, make sure that you
remove the fiber‐optic cable before you remove the module from the switch
port.
following illustration.
25.