RS2052 EN
4/12/05
11:32 AM
Page 10
Getting Started
Unpacking the system
EN
You should have the following:
• one main unit (with 2 main speakers);
• one remote control;
• one AM loop antenna;
• one Digital Audio Player;
• one user's guide;
• one safety leaflet;
• Owner registration Card.
!
Warning:
Use of this product is for your personal use
only. Unauthorized recording or duplication
of copyrighted material may infringe upon
the rights of third parties and may be
contrary to copyright laws.
Note:
Make sure the tracks are encoded in mp3
or Windows Media formats and supported
bitrates. Bitrates supported by the player:
mp3 – 32 to 320kbps
wma – 48 to 160kbps
3
Back View
3
1
2
4
1. FM Pigtail Antenna.
2. Main Speaker Jacks.
3. AM Loop antenna Jacks.
4. AUX IN
Getting Started
Using the FM and AM Antennas
Before you use your audio system, you'll want to
make sure both the FM and AM antennas are
positioned properly. Uncoil the FM antenna at
the back of the unit, making sure it is fully
extended (you may even want to tape it to the
wall behind the unit if possible. The higher the
better.) You'll also need to connect the AM
antenna loop to the back of the unit if you listen
to AM stations. Rotate the AM loop antenna for
better reception.
Connecting the Speakers
Each speaker has a black (negative) and a red
(positive) jack. When connecting the speakers,
match the red wires to the red jacks and the
black wires to the black jacks.
Speaker Wire Connection
Push Speaker terminal tab
Release tab to lock wire in
down to insert wire.
the terminal.
NOTE: Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
Front View
4 inches
ON/STANDBY
SOURCE
MEMORY CARD
TUNE/PRESET
4 inches
4 inches
DISC 1
BACK
SELECT
RECORD
DISC 2
DELETE
DISC 3
DISC 4
BAND/CD INFO
DISC 5
CD-R / RW COMPATIBLE
mp3
5
DISC CHANGER
Side View
4 inches
2
inches
4
EN