Table of Contents
Advertisement
Getting Started
Unpacking the system
EN
You should have the following:
• one main unit (with 2 main speakers and a
subwoofer);
• one remote control;
• one AM loop antenna;
• one user's guide;
• one safety leaflet;
• Owner registration Card.
Back View
1
2
3
1. Main speaker jacks (high pass)
2. Woofer jacks (low pass)
3. Subwoofer jacks
4. FM pigtail antenna
5. AM loop antenna jack
Using the FM and AM Antennas
Before you use your audio system, you'll want to
make sure both the FM and AM antennas are
positioned properly. Uncoil the FM antenna at
the back of the unit, making sure it is fully
extended (you may even want to tape it to the
wall behind the unit if possible, the higher the
better.) You'll also need to connect the AM
antenna loop to the back of the unit if you listen
to AM stations. Rotate the AM loop antenna for
better reception.
Speaker Wire Connection
Push speaker terminal tab
down to insert wire.
NOTE: Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
2
4
5
Release tab to lock wire in
the terminal.
Connecting the Main Speakers
Each speaker has a black/red wire and a
black/purple wire. When connecting the speakers,
match the red/purple wires to the red/purple
jacks and the black wires to the black jacks on the
main unit.
Subwoofer Connection
Connect the green wire on your subwoofer to the
green terminal and the black wire to the black
terminal of the Subwoofer jack.
Installation
To ensure sufficient ventilation, keep the
minimum spacings shown below free from other
surfaces:
Front View
4 inches
Side View
2 inches
4 inches
4 inches
4 inches
Hide quick links:
Advertisement
Table of Contents
