Table of Contents
Advertisement
Getting Started
EN
Installation
To ensure sufficient ventilation, keep the spacing
shown below:
10 cm/
4"
R S 2 0 2 2
DIGITAL MICRO HI-FI SYSTEM
MULTI FUNCTION FLUORESCENT DISPLAY
TUNING
DIGITAL PLL SYNTHESIZED TUNER
CD-R / RW COMPATIBLE
˚
BAND•APP
AUX
CD
TUNER
TA P E
@
ON
STAND-BY
CLOCK/
PROG•SET
TIMER
REC•
REC•
• PRESET •
CLEAR
DN
UP
DIMMER
DISPLAY
ST•MO
X-BASS
IR SENSOR
EQ
VOLUME
DEMO
10cm
OPEN•
CLOSE
DIGITAL LOGIC DECK
PLAYBACK/ RECORD
/ 4"
Connecting the Speakers
When connecting the speakers, match the red
wires to the red jacks and the black wires to the
black jacks. Each speaker has a black and a red
jack, one for positive and one for negative. The
top two jacks are for the left speaker, while the
bottom two jacks are for the right speaker.
R
1
RS2022 EN
1. FM antenna
2. AM loop antenna
connector
3. AUX IN jack
1
FM
ANT
4. Main speaker jacks
2
AM
ANT
3
R
L
@
/AUX
IN
4 1
10 cm/
4"
5cm
/2"
10cm
/ 4"
L
FM
ANT
AM
ANT
R
L
@
/AUX
IN
6
Unpacking the unit, you'll have:
1. The main unit
2. One remote control
3. Two speakers
4. One user manual
5. One AM loop antenna
6. Owner registration card
Speaker Wire Connection
Push terminal tab
down to insert wire.
NOTE: Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
Using the Antenna
Before you use your audio system, you'll want to
make sure the FM antenna is positioned properly.
The FM antenna is the coiled wire connected to
the back of the unit. Uncoil it, making sure it is
fully extended (you may even want to tape it to
the wall behind the unit, if possible. The higher,
the better.)
For better AM reception, move or rotate the AM
loop antenna.
Installing Batteries
The remote control must be inserted with 2
"AAA" batteries prior to use. Follow the steps
below to ensure correct installation.
1. Open the battery compartment door (located at
the back of the remote control) and lift the
door.
2. Change step 2 to read, "Before inserting the
batteries, observe the polarities of the batteries
and the engraved polarity diagram inside the
battery compartment. When inserting the
batteries into the remote control, make sure the
polarities of the batteries match the engraved
polarity diagram inside the battery
compartment." This has a better flow and easier
to follow.
3. After installing the batteries, place the battery
compartment door in place and slide in the
opposite direction of the arrow (the reverse of
step 1).
12/11/02, 11:00 AM
Release tab to lock wire in
the terminal.
Advertisement
Table of Contents
