Battery - DFI PIC-Q170/H110 User Manual

PIC-Q170/H110
► Internal I/O Connectors ► Expansion Slots
Please follow the steps below to install the card into the socket.
Chapter 2 - Hardware Installation
► Internal I/O Connectors

Battery

Step 1:
Insert the card into the socket
at an angle while making sure
the notch and key are perfectly
aligned.
Step 2:
The lithium ion battery addendum supplies power to the real-time clock and CMOS memory as
Press the end of the card far
an auxiliary source of power when the main power is shut off.
from the socket down until
against the stand-off.
Safety Measures
Step 3:
Screw tight the card onto the
stand-off with a screw driver
and a stand-off screw until
the gap between the card and
the stand-off closes up. The
card should be lying parallel to
the board when it's correctly
mounted.
26
• There exists explosion hazard if the battery is incorrectly installed.
• Replace only with the same or equivalent type recommended by the manufacturer.
• Dispose of used batteries according to local ordinances.
www.dfi.com
Battery