PIC-Q170/H110
► Advanced
Active Management Technology Support
InsydeH2O Setup Utility
Advanced
Active Management Technology Support
Intel AMT Support
<Enabled>
Un-Configure ME
<Disabled>
F1
Help
↑ /↓
Select Item
Esc
Exit
←/→
Select Item
Intel AMT Support
Enabled
Enable AMT. When this field is enabled, the user is allowed to configure AMT
settings via MEBX.
Disabled Disable AMT. When this field is disabled, AMT settings cannot be configured
and MEBX is not allowed to enter.
Un-configure ME
Enable or disable ME unconfiguration without password.
Chapter 3 - BIOS Settings
Rev. 5.0
When disabled AMT BIOS Fea-
tures are no longer supported
and user is no longer able to ac-
cess MEBx Setup.
Note :
This option does not disable
Manageability Features in FW.
F5/F6
Change Values
F9
Setup Defaults
Enter
Select
SubMenu
F10
Save and Exit
► Advanced
Debug Configuration
This section configures Debug setting.
Advanced
Debug Configuration
Dynamic EFI DEBUG
<Off>
EFI debug print level
[0x8000004F]
EFI debug serial port
[0x3F8]
EFI debug baud rate
[115200]
F1
Help
↑ /↓
Select Item
Esc
Exit
←/→
Select Item
Dynamic EFI DEBUG
This field is used to turn on or off the function to output debug message from COM port.
When this field is set to "On", the following EFI debug configurations will be displayed.
EFI debug print level
Default value is 0x8000004F.
EFI debug serial port
Default value is 0x3F8.
EFI debug baud rate
Default value is 115200.
34
www.dfi.com
InsydeH2O Setup Utility
Enable it to output debug mes-
sage from COM port.
F5/F6
Change Values
F9
Setup Defaults
Enter
Select
SubMenu
F10
Save and Exit
Rev. 5.0