Advertisement
PROBLEM
Oil leak.
Oil Cover is
difficult to remove.
Note: if you are unable to fix the problem by following the above prompts, or one of the
situations below occurs, please unplug the rangehood straight away and contact our
after-sales service centre.
1
The rangehood runs unevenly when turned on;
2
The rangehood makes an unusual noise during operation;
3
Strange odours, heat or smoke are discovered, or other unusual circumstances not
mentioned above occur.
The following phenomenon is not a malfunction
PHENOMENON
The product makes a clicking
noise after the power is switched
off for a few seconds.
TROUBLESHOOTING
POSSIBLE CAUSE
Too much oil in the oil
receptacle.
Oil cover has not been
cleaned.
Main housing hasn't been
cleaned.
Cover and cover recess have
not been cleaned.
CAUSE
Air pressure causes the two blades of the check valve
to open during operation. After the power supply is
switched off, the fan gradually stops rotating and the
blades fall back by themselves, emitting a clicking
noise.
WHAT TO DO
Remove waste oil in the oil receptacle.
Clean the oil cover in accordance with
the instructions.
Wipe the main housing every day
after use in accordance with the
instructions.
Clean the oil cover and cover recess
weekly in accordance with the
instructions.
17
Advertisement
