Bosch AutoDome 700 Series Installation Manual page 29

AutoDome 700 Series IP PTZ Camera
3.
CAUTION!
If you feel any resistance when rotating the dome housing or when engaging the connector,
stop immediately and start over.
4.
CAUTION!
You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs)
to ensure a proper seal between the arm and the housing.
Bosch Security Systems, Inc.
Rotate the dome housing down to a vertical position and gently push upward to engage
the connector on top of the dome housing.
Hold the Pendant housing in position while tightening the two (2) 5-mm Allen head
mounting screws on top of the housing to 10-12 N-m (90-105 in.-lbs).
Installation Manual
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 29
F.01U.215.779 | 1.0 | 2011.07