Sub-Zero ICBBI Series Installation Information page 8

International Built-In
International Built-In
Water Line Connections
Approximately .9 m (3') of 6.35 mm (1/4") OD plastic
tubing is connected to the unit with a preassembled
6.35 mm (1/4") compression connection at the end. This
tubing is located under the unit.
The water line fitting connection kit, provided with the
unit, contains a 6.35 mm (1/4") compression union fit-
ting for connection to the household water supply line.
The compression nut and sleeve should be placed on
the water line and fastened to the connection at the end
of the tubing under the unit. Do not over tighten.
Check all water line fittings for leaks. Make sure that
the drain pan can be installed and/or removed without
any water line interference.
IMPORTANT NOTE: The water line should be purged
prior to final connection to the unit. This will remove
any debris that may be present in the tubing from
installing the new water line.
IMPORTANT NOTE: The customer should be made
aware that the ice maker will not produce ice immedi-
ately, and that the first few batches of ice produced
should be discarded, allowing twenty-four (24) hours for
proper ice production.
IMPORTANT NOTE: Caution must be taken to not
expose the water lines leading to the refrigerator to
freezing temperatures. Failure to do so could cause
damage to the product and home.
Series
Series
(ICBBI)
(ICBBI)
Water Filter
A water filter is available from a Sub-Zero dealer or
parts distributor.
NOTE: Whenever the water filter or the filter bypass
plug is removed from the unit, the water supply will be
interrupted.
2-9
Installation Information
7025630 - Revision A - April, 2012