Table of Contents
Advertisement
34
GETTING TO KNOW YOUR VEHICLE
independently. The heated seat switches for each heater
are located on the rear of the center console.
You can choose from HI, LO, or off heat settings. Amber
indicator lights in each switch indicate the level of heat in
use. Two indicator lights will illuminate for HI, one for LO
and none for off.
Push the switch once to turn the HI setting on.
Push the switch a second time to turn the LO setting on.
Push the switch a third time to turn the heating elements
off.
The level of heat selected will stay on until the operator
changes it.
NOTE:
The engine must be running for the heated seats to
operate.
F
V
S
RONT
ENTILATED
EATS
I
E
F
QUIPPED
The ventilated seats control buttons are
located on the center stack below the radio
screen, or within the Uconnect system. The
fans operate at three speeds: HI, MED,
and LO.
Press the ventilated seat switch once to choose HI.
Press the ventilated seat switch a second time to
choose MED.
Press the ventilated seat switch a third time to
choose LO.
Press the ventilated seat switch a fourth time to turn
the ventilation off.
NOTE:
The engine must be running for the ventilated seats to
operate.
For information on use with the Remote Start system, see
page 19.
Ú
H
R
EAD
ESTRAINTS
Head restraints are designed to reduce the risk of injury by
restricting head movement in the event of a rear impact.
Head restraints should be adjusted so that the top of the
head restraint is located above the top of your ear.
All occupants, including the driver, should not
operate a vehicle or sit in a vehicle's seat until the
head restraints are placed in their proper positions in
—
order to minimize the risk of neck injury in the event
of a crash.
Head restraints should never be adjusted while the
vehicle is in motion. Driving a vehicle with the head
restraints improperly adjusted or removed could
cause serious injury or death in the event of a colli-
sion.
WARNING!
Front Head Restraints
Your vehicle is equipped with front four-way driver and
passenger head restraints.
To raise the head restraint, pull upward on the head
restraint. To lower the head restraint, push the adjustment
button, located at the base of the head restraint, and push
downward on the head restraint.
NOTE:
The head restraints should only be removed by qualified
technicians, for service purposes only. If either of the head
restraints require removal, see an authorized dealer.
Head Restraint Adjustment Button Location
Advertisement
Table of Contents
