Table of Contents
Advertisement
2.
There are glove compartment travel stops on both
sides of the glove compartment door. Partially close
the glove compartment door and push inward to
release the glove compartment travel stop on one
side and repeat this procedure for the opposite side.
3.
Pull the right hand side of the glove compartment
door toward the rear of the vehicle to disengage the
glove compartment door from its hinges.
NOTE:
When disengaging the glove compartment door from its
hinges, there will be some resistance.
4.
With the glove compartment door loose, remove the
glove compartment tension tether and tether clip by
sliding the clip toward the face of the glove
compartment door and lifting the clip out of glove
compartment door.
Right Side Of Glove Compartment
1 — Glove Compartment Tension Tether
2 — Glove Compartment Door
5.
Remove the filter cover by disengaging the retaining
tab and mid way snap that secures the filter cover to
the HVAC housing. Disengage the mid way snap by
pulling the door outward. Unhinge the filter cover on
the right side to fully remove the cover.
Cabin Air Filter Cover
1 — Retaining Tab
2 — Mid Way Snap
3 — Filter Cover Hinge
6.
Remove the cabin air filter by pulling it straight out of
the housing.
7.
Install the cabin air filter with the arrow on the filter
pointing toward the floor. When installing the filter
cover, make sure the retaining tabs fully engage the
cover.
SERVICING AND MAINTENANCE
CAUTION!
The cabin air filter is identified with an arrow to indicate
airflow direction through the filter. Failure to properly
install the filter will result in the need to replace it more
often.
8.
Reinstall the glove compartment door on the door
hinge and reattach the tension tether by inserting the
tether clip in the glove compartment and sliding the
clip away from the face of the glove compartment
door.
9.
Push the door to the near closed position to reengage
the glove compartment travel stops.
NOTE:
Ensure the glove compartment door hinges and glove
compartment travel stops are fully engaged.
A
D
B
I
CCESSORY
RIVE
ELT
NSPECTION
WARNING!
Do not attempt to inspect an accessory drive belt
with vehicle running.
When working near the radiator cooling fan, discon-
nect the fan motor lead. The fan is temperature
controlled and can start at any time regardless of
ignition position. You could be injured by the moving
fan blades.
225
8
(Continued)
Advertisement
Table of Contents
