Table of Contents
Advertisement
Pulling Down The Carpet Floor Panel To Access Top Tether
Strap (3rd Row Bench)
Tether Anchorages (3rd Row Bench)
LATCH-compatible child restraint systems will be equipped
with a rigid bar or a flexible strap on each side. Each will
have a hook or connector to attach to the lower anchorage
and a way to tighten the connection to the anchorage.
Forward-facing child restraints and some rear-facing child
restraints will also be equipped with a tether strap. The
tether strap will have a hook at the end to attach to the top
tether anchorage and a way to tighten the strap after it is
attached to the anchorage.
Center Seat LATCH — Five Or Seven
Passenger Vehicles Second Row Seating
Only
WARNING!
Do not install a child restraint in the center position
using the LATCH system. This position is not
approved for installing child seats using the LATCH
attachments. You must use the seat belt and tether
anchor to install a child seat in the center seating
position.
Never use the same lower anchorage to attach more
than one child restraint. For typical installation
instructions, see
page 192.
Ú
Vehicle With A Center Arm Rest Tether —
Five Or Seven Passenger Seating Only
For rear-facing child restraints secured in the center seat
position with the vehicle seat belts, the rear center seat
position has an armrest tether that secures the arm rest
in the upward position.
1.
To access the center seat arm rest tether, first lower
the arm rest. The tether is located behind the
armrest and hooked onto the plastic seat backing.
Center Seat Position Arm Rest Tether
2.
Pull down on the tether to unhook it from the plastic
seat backing.
Center Seat Position Arm Rest Tether
3.
Raise the armrest and attach the tether hook to the
strap located on the front of the arm rest.
SAFETY
191
6
Advertisement
Table of Contents
