13.3
Removing the rear wheel
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
Long-life grease (
–
Insert the spacers.
H00935-10
–
Clean and grease wheel spindle
Long-life grease (
–
Position the front wheel.
The brake linings are correctly positioned.
–
Insert the wheel spindle.
–
Tighten screws
Guideline
E00545-10
Screw, fork stub
–
Mount and tighten screw
Guideline
Screw, front
wheel spindle
–
Loosen screws
–
Remove the motorcycle from the lift stand. (
E00547-11
–
Operate the hand brake lever several times until the brake
linings are seated correctly against the brake disc.
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
E00546-10
Preparatory work
–
Raise the motorcycle with a lift stand. (
WHEELS, TIRES 13
1
and contact
of the spacers.
p. 119)
2
.
p. 119)
3
.
M6
4
.
M10
40 Nm (29.5 lbf ft)
3
.
3
.
M6
10 Nm (7.4 lbf ft)
®
Loctite
243™
p. 40)
10 Nm (7.4 lbf ft)
p. 40)
87