Installing The Fork Legs - Husqvarna TC 65 2022 Owner's Manual

11.8

Installing the fork legs

SERVICE WORK ON THE CHASSIS 11
–
Loosen screws
–
Loosen screws
F02918-10
Main work
–
Position the fork legs.
Bleeder screws
Info
The second milled groove (from the top) must be flush
with the upper edge of the upper triple clamp.
F02179-10
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
F02918-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Position the brake line and the clamp. Mount and tighten
5
screws .
Guideline
Screw, brake line
S01484-11
holder
Clamp the brake line only via the metal bushing.
Make sure that the upper edge of the bushing is as flush as
possible with the bracket.
Finishing work
–
Install the front wheel.
3
. Remove the left fork leg.
4
. Remove the right fork leg.
1
are positioned toward the rear.
2
.
M8 20 Nm (14.8 lbf ft)
3
.
M8 15 Nm (11.1 lbf ft)
M8 20 Nm (14.8 lbf ft)
EJOT 1.7 Nm (1.25 lbf ft)
( p. 86)
4
.
®
Loctite 243™
43