Installing the cooker
Note the following when installing the
cooker:
– There must not be a unit rear panel
fitted behind the cooker.
– If an interim shelf is fitted beneath
the oven, a cut-out is required as
close to the wall as possible to en-
sure that there is sufficient ventilation
for the appliance.
The shape of the cut-out is not im-
portant, as long as cut-out measures
at least 150 cm
Do not fit insulation material inside
the housing unit. This would hinder
the intake of air to cool the appli-
ance.
70
2
.
Turn off the mains electricity supply
to the isolator.
^ Connect cooker cable to isolator.
^ Align the cooker in front of the base
unit.
^ Connect the hob plug to the socket
on the cooker.
^ Push the appliance into the oven
base unit as far as the oven trim and
align.
^ Then open the oven door and screw
the oven to the side panels of the
base unit through the two holes, one
on each side of the oven trim.
The appliance must only be oper-
ated when it has been built in.