Solid-State Drive - HP Spectre x360 Convertible Maintenance And Service Manual

Solid-state drive

Description
512-GB, M2, SATA3 solid-state drive supporting TLC
256-GB, M2, SATA3 solid-state drive supporting TLC
128-GB, M2, SATA3 solid-state drive supporting TLC
1-TB, PCIe-3×4, NVMe solid-state drive supporting TLC
512-GB, PCIe-3×4, NVMe solid-state drive supporting TLC
256-GB, PCIe-3×4, NVMe solid-state drive supporting TLC
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the PM2.0×2.9 screw (1) that secures the solid-state drive to the bottom cover. (The solid-state
drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
24 Chapter 5 Removal and replacement procedures
Bottom cover on page 19).
Spare part number
801504-001
801503-001
801502-001
851590-001
853323-001
856221-001
Battery on page 21).