Table of Contents
Advertisement
Using the Remote Supervisor II Web Interface
The Remote Supervisor II Web Interface is a graphical user interface that you can
use to perform many of the tasks that were previously only available through the
Configuration/Setup Utility program. The Remote Supervisor II Web Interface is in
the Remote Supervisor Adapter II integrated service processor and is accessed
using a Web browser on the administrator console or another computer that is
connected to the server through the SP serial connector on the rear of the server.
Before using the Remote Supervisor II Web interface, read the following
information:
v A Remote Supervisor Adapter II SlimLine must be installed in the server.
v You must have a Web browser to access the Web interface.
v You must know the IP address or the host name of the Remote Supervisor
v The IP address and the host name can be found in the Configuration/Setup
v You can connect directly to the server or use an Ethernet network to access the
v The following cable connections are required:
See the User's Guide on the IBM Documentation CD for instructions.
36
IBM System x3800 Type 8865: Installation Guide
Adapter II SlimLine that you are connecting to.
Utility program or from your network administrator.
service processor and the Remote Supervisor Adapter II Web Interface.
– Crossover cable from the SP connector to a computer.
– An Ethernet cable that is connected to an Ethernet network.
Advertisement
Table of Contents
