Installing A Serveraid-8I Adapter - IBM 8865 Installation Manual

4. Note the location of the internal cables connected to the I/O board; then,
5. Remove the I/O board from the server and place the I/O board on a flat,
6. Insert the front of the adapter into the front standoff; then, rotate the rear of the
7. Press the Remote Supervisor Adapter II SlimLine firmly into the connector.
8. Reinstall the I/O board in the server and reconnect the internal cables to the I/O

Installing a ServeRAID-8i adapter

If you are installing an optional ServeRAID-8i adapter, review the following
information:
v A ServeRAID-8i adapter can be installed only in the dedicated slot on the PCI-X
v The ServeRAID-8i adapter is not cabled to the server, and no rerouting of the
The following illustration shows how to install a ServeRAID-8i adapter.
For more detailed instructions or information, see the User's Guide on the IBM
Documentation CD.
remove the cables from the I/O board and move them out of the way.
static-protective surface with the connectors facing up.
adapter into the rear standoff.
board.
board.
SAS cables is required.
ServeRAID-8i
slot
ServeRAID-8i adapter
Chapter 2. Installing options
21