Configuring And Installing A Tabletop Tape Drive With Scsi Interface; Tabletop Fibre Channel Tape Drive Model - Quantum SDLT 600 User Manual

Configuring and Installing a Tabletop Tape Drive with SCSI
Interface
Tabletop Fibre Channel
Tape Drive Model
SDLT 600 Product Manual

Configuring and Installing a Tabletop Tape Drive with SCSI Interface

This section provides instructions for configuring and installing the
tabletop Fibre Channel model of the SDLT 600 tape drive.
Follow these steps to connect a tabletop Fibre Channel SDLT 600 tape
drive:
3
1 Prior to connecting the SDLT 600 tape drive to the host computer, be
certain the tape drive and computer are turned off.
2 Remove the Fibre Channel protective caps from the rear of the drive.
3 Remove the fiber optic cable protective caps and insert the fiber optic
cables into the Fibre Channel connector, as shown in
connector is fully seated when it snaps into the port.
You can connect a Fibre Channel connector while the tape
Note:
drive is still powered on; this capability is known as "hot-
swappable" or hot-pluggable."
When connecting to the Fibre Channel port, make sure to
use a 50μM Fiber core fiber optic cable with an LC, Duplex
connector.
Chapter 3 Installing Your Tape Drive
figure
3
17. The
65