Table 32 Dual-Color Drive Density Led Appearance For Type Of Data Cartridge Loaded - Quantum SDLT 600 User Manual

Table 32 Dual-Color Drive
Density LED Appearance for
Type of Data Cartridge Loaded
Possible Data Cartridge Scenario
No data cartridge is inserted
SDLT 600 tape drive formatted Super DLTtape II
data cartridge inserted
Blank Super DLTtape II data cartridge inserted
Super DLTtape II data cartridge ejected
SDLT 220 tape drive formatted Super DLTtape I data
cartridge inserted
SDLT 320 tape drive formatted Super DLTtape I data
cartridge inserted
Blank Super DLTtape I data cartridge inserted
Any Super DLTtape I data cartridge ejected
DLT VS160 tape drive formatted DLTtape VS1 data
cartridge inserted
Blank DLTtape VS1 data cartridge inserted
DLTtape VS1 data cartridge ejected
Any DLTtape IV data cartridge inserted
SDLT 600 tape drive
SDLT 600 Product Manual
On the SDLT 600 tape drive, the leftmost LED is dual color (green/
orange). This LED is the Density Indicator. When you insert a Super
DLTtape II data cartridge, this LED illuminates green. When the tape
drive detects a backward read compatible (BRC) data cartridge, this LED
illuminates orange. (The SDLT 600 tape drive backward reads Super
DLTtape I data cartridges formatted in an SDLT 220 or SDLT 320 tape
drive, or DLTtape VS1 data cartridges formatted in a VS160 tape drive.)
If a DLTtape IV data cartridge is inserted, the Drive Density LED is off.
Table 32 summarizes these combinations.
reset
Chapter 4 Using Your Tape Drive
Front Panel Controls and LEDs
LED Color/State
Off
Green/On
Green/On
Green/Remains On
Orange/On
Orange/On
Orange/On
Off
Orange/On
Orange/On
Off
Off
All LEDs illuminate briefly and then illuminate
in sequence until the reset completes