COMFORT-AIRE Century VMH-SV Series Service Manual page 87

9. PCB board 9
Procedure
1) Disconnect the connector for
compressor and release the ground
wire(1 screw). (see CJ_ODU_
PCB_009-1 ).
2) Pull out the wires from electrical
supporting plate and turn over the
electronic control assembly. (see
CJ_ODU_PCB_009-2 ).
3) Remove the electronic installing box
subassembly (4 hooks) (see CJ_ODU_
PCB_009-3 ).
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
Outdoor Unit Disassembly 27
 Outdoor Unit Disassembly 59
Outdoor Unit Disassembly 29
CJ_ODU_PCB_009-1
CJ_ODU_PCB_009-2
CJ_ODU_PCB_009-3
