Intrusion Switch; Removing The Intrusion Switch - Dell E33S001 Owner's Manual

Figure 18. Inside the system—two 3.5-inch cabled hard drive systems
1 control panel module
3

intrusion switch

5 expansion card riser
7 processor
9 cooling fan blank
11 optical drive
Intrusion switch

Removing the intrusion switch

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Ensure that you follow the
2 Follow the procedure listed in
3 Keep the plastic scribe ready.
Steps
1 Disconnect the intrusion switch cable from the connector on the system board.
2 Using the plastic scribe, slide the intrusion switch out of the intrusion switch slot.
58 Installing and removing system components
Safety instructions.
Before working inside your
2 cabled hard drive
4 power supply unit
6 memory module (A1, A2, A3, A4)
8 system board
10 cooling fan (3)
system.