Manufacturer's Warranty; Further Information; Originele Handleiding; Informatie Over De Handleiding - Hilti NURON STR 4-22 Manual

Trouble or fault
Nut cannot be screwed on to
the cut threaded rod.
Product does not start even
though the control switch is
pressed.
Cutting blade cannot be in-
stalled (securing screw can-
not be screwed in).
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

Further information

For more information on operation,
qr.hilti.com/manual/?id=2362838&id=2362890
This link is also to be found at the end of the operating instructions, in the form of a QR code.

Originele handleiding

1

Informatie over de handleiding

1.1 Bij deze handleiding
• Lees voor ingebruikname deze handleiding door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze handleiding en op het product in acht
nemen.
• De handleiding altijd bij het product bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
*2362838*
Possible cause
Burr formation at cut edge.
Function selector switch is in the
position and the cutting arm is
fully open.
Cutting blades installed wrong way
round.
technology,
2362838
Action to be taken
▶ Check the cut face for burrs;
deburr the cut if necessary.
→ page 24
▶ Set the function selector switch
to .
▶ Check the orientation of the
cutting blades:
▶ Movable cutting arm → narrow
side of the cutting blade up.
▶ Stationary cutting arm →
broad side of the cutting blade
up.
environment and recycling, follow this link:
Nederlands 27