Table of Contents
Advertisement
We value your experience using Sunny Health and Fitness products. For assistance with parts
or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907- 8669).
STEP 2
A: Connect the Pulse Connecting
Wire
1
Connecting Wire 2 (No. 24) and
connect the Sensor Wire (No. 21) to
the Sensor Connecting Wire (No. 22)
nsert the Tension Hook (No. 20) from
I
the Main Frame (No. 1) to the inside
tube of the Handlebar Post (No. 2),
then pull it out of the hole on the
Handlebar
connect Tension Hook (No. 20) with
Tension Controller (No. 28) as shown
in Diagram A.
Note:
Make
Controller (No. 28) is at the lowest
level before you connect the cable. This
ensures the wires are at their longest
point. We recommend the assistance of
a second person to help hold the
Handlebar Post (No. 2). This will make
the connection easier when you are
attaching Tension Hook (No. 20) to the
cable.
B: Remove the preassembled Rear
Cover (No. 29), Flat Washer (No. 30)
and Screw (No. 31) from the Tension
Controller (No. 28) with Spanner (No.
88). Lock the Tension Controller (No.
28) to the Handlebar Post (No. 2) with
the Rear Cover (No. 29), Flat Washer
(No. 30) and Screw (No. 31) with the
Spanner (No. 88).
C: Insert the Handlebar Post (No. 2)
into the post of the Main Frame (No.
1); secure with
4
14) and
Allen Wrench (No. 87).
Note: Ensure that all bolts and washers
are in place and partially threaded in
before completely tightening any of
them.
6
(No.
23)
to
the
Post
(No.
2).
sure
the
Tension
4
Arc Washers (No.
Screws (No. 27) with the
Pulse
.
Finally
Advertisement
Table of Contents
