Open Scan (Os) Mode - Uniden X66 Owner's Manual

Operation
Add/Remove Channels from SCAN Memory
Select OS Scanning Mode. Select the channel you want to store.
Press [MEM]. MEM icon appears and a beep tone sounds.
To remove the channel from SCAN memory, press [MEM] once more.
The MEM icon disappears.

Open Scan (OS) Mode

Open Scan is the default Scan Mode.
All UHF-CB channels have been added to the
OS SCAN Memory for convenience. To add/
remove channels from OS SCAN Memory,
refer to p.24.
Allows continuous scanning of all selected
channels. If an active channel is found,
scanning will stop on that channel. If the
received signal ceases, the unit will wait 3
seconds for the signal to return, otherwise scanning resumes.
After transmission in scan mode, the unit will wait 20 seconds for the
signal to return, otherwise scanning resumes.
To deactivate SCAN, press [SCAN].
If SCAN is deactivated while on an active channel, the
X66 will stay on that active channel. If no channels are
active, the X66 will reinstate the starting channel.
NOTE
OS Mode is indicated by the absence of the GS icon.
NOTE
UNIDEN X66
19
UHF CB Transceiver