Priority Watch; Add/Remove Channels From Scan Memory - Uniden X66 Owner's Manual

Operation

Priority Watch

To switch Priority Watch On/Off;
1. Press [MENU/ENTER] four times.
2. Press /
to change the setting between ON or OFF.
3. Press [MENU/ENTER] to store the setting.
4. Press and hold [MENU/ENTER] to save & exit from the menu mode.
If SCAN is deactivated while it is tuned to an active channel,
the UHF CB Radio will stay on that active channel.
If none of the channels are active, the UHF CB Radio will
NOTE
reinstate the scan start channel.
If OS/GS Scanning is initiated when there are no channels
programmed in OS/GS memory, an error tone will be
heard and scanning will not start (see Programming Scan
NOTE
Channels - below).

Add/Remove Channels from SCAN Memory

Select which Scanning Mode you wish to use
- OS or GS. Select the channel you want to store.
Press [MEM] to store. MEM icon appears
and a short tone beep is heard.
To remove the channel from SCAN memory,
press [MEM] once more.
The MEM icon disappears.
UNIDEN X66
on the Remote SPK/MIC
24
UHF CB Transceiver