Troubleshooting; Accessories; Technical Data - Gardena ErgoCut 58 Operating Instructions Manual

6. Troubleshooting

Fault
Hedge trimmer does not start
Hedge is not cleanly cut
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
A
authorised by GARDENA.

7. Accessories

GARDENA Maintenance Oil

8. Technical Data

Power consumption, motor
Voltage / Frequency
Strokes
Length of cutter blade
Tooth gap of cutter blade
Weight
Workplace related
sound pressure level L
Uncertainty K
pA
Noise emission value L
Hand / arm vibration a
Measuring process complying with 1) EN 774 2) EU-directive 2000 / 14 / EC. The stated vibration emission value has been measured
according to a standardised test procedure and can be used for comparison of one electric power tool with another. It can also be used
for preliminary evaluation of exposure. The vibration emission value can vary during actual use of the electric power tool.
DANGER ! Electric shock !
V Always unplug the mains plug and slide the
A
Possible Cause
Extension cable not plugged
in or is damaged.
Cutting unit not locked in 0° or
90° position.
Blade blunt or damaged.
Extends the life of the blade.
ErgoCut 48 (Art. 8875)
550 W
230 V / 50 Hz
2,800 / min.
48 cm
27 mm
3.7 kg
84 dB (A)
pA 1)
3 dB (A)
measured 94 dB (A) /
WA 2)
guaranteed 95 dB (A)
< 2.5 m / s 2
vhw 1)
1
protective cover over the cutter blade
before troubleshooting.
Remedy
v Plug in the extension cable
v Lock cutting unit in 0° or
v Have blade replaced by
ErgoCut 58 (Art. 8876)
550 W
230 V / 50 Hz
2,800 / min.
58 cm
27 mm
3.8 kg
85 dB (A)
measured 95 dB (A) /
guaranteed 96 dB (A)
2
or if necessary replace it.
90° position.
GARDENA-Service.
Art. 2366
3 dB (A)
15