Table of Contents
Advertisement
Quick Start Guide
GFK-3000B
2 Hardware Installation
The Energy Pack can be mounted on a standard EN50022 DIN rail or an equipment
panel. It is designed to be mounted adjacent to the Controller and connected to the
Controller using the provided cable (IC695CBL003).
Heat dissipation: When mounting the Energy Pack, allow a minimum clearance of
25.4mm (1 inch) on all four sides of the unit (right, left, top and the bottom).
2.1
Mounting the Energy Pack on a DIN Rail
The Energy Pack snaps easily onto the DIN rail. No tools are required.
1)
Incline Energy Pack so that top edge of plastic recess (
top of DIN rail
2)
Swivel the Energy Pack so that bottom spring-loaded plastic clip engages
bottom of DIN rail.
3)
Listen for click as plastic clip springs back, securing the Energy Pack onto
the DIN rail.
Hardware Installation
Chapter 2
Sep 2019
) engages
Figure 2.1
4
Advertisement
Table of Contents
