Buttons - Tecnoware EVO DSP PLUS 1.200 PF 0.9 User Manual

Programmable Output information
Mode operation information
Graphic LCD Panel
Battery information
Input and Battery Voltage information

5.1.2 Buttons

Functions of the buttons are given below:
Button Function
Turn ON the UPS: press and hold ON/MUTE button for at least 3 seconds to turn ON the UPS.
Mute the acoustic alarm: when the UPS is in Battery mode, press and hold this button for at
least 5 seconds to disable or enable the acoustic alarm. But it's not applied to the situations
ON/MUTE
when warnings or errors occur.
Test Battery: press and hold ON/MUTE button for at least 5 seconds to perform the Battery Test
while the UPS is in Normal mode.
Select the measurements on the graphic display: by pressing the SELECT button it is possible
to choose the electrical parameter to be displayed (Input Voltage, Input Frequency, Battery
SELECT Voltage, Output Voltage, Output Frequency). If the button is not pressed for at least 10 seconds,
then the default parameter will come back on the graphic display (the default parameters are
Input Voltage and Output Voltage).
Turn OFF the UPS: press and hold ON/MUTE button for at least 3 seconds to turn OFF the UPS.
OFF
By pressing this button while the UPS is in Normal mode, the UPS will go to Stand-by mode; by
UPS EVO DSP PLUS
Indicates the load or the Output is short-circuited.
Indicates that there is an active scheduling for the programmable Output.
Indicates the UPS connects to the mains.
Indicates the Battery is working.
Indicates the Bypass circuit is working.
Indicates the Inverter circuit is working.
Indicates the Output is working.
Function
Indicates the Battery capacity by 0-25%, 26-50%, 51-75%, and 76-100%.
Indicates the Battery is faulty or defective.
Indicates Low Battery level and Low Battery Voltage.
Indicates the Input Voltage or Frequency or Battery Voltage.
Vac: Input Voltage, Vdc: Battery Voltage, Hz: Input Frequency
9
ENGLISH
User's manual