Table of Contents
Advertisement
Confirming that Measurement & Automation
Explorer (MAX) Recognizes the Device
Use Measurement & Automation Explorer (MAX) to configure your NI hardware. MAX
informs other programs about which devices reside in the system and how they are configured.
MAX is automatically installed with FlexRIO Support.
1.
Launch MAX by navigating to Start»All Programs»National Instruments»NI MAX or
by clicking the NI MAX desktop icon.
2.
In the Configuration pane, double-click Devices and Interfaces to see the list of installed
devices. Installed devices appear under the name of their associated chassis.
(PXI and PXI Express devices only) Expand your Chassis tree item. MAX lists all
3.
devices installed in the chassis. Your default device names may vary.
Note
installed devices. If the device is still not listed, power off the system, ensure
the device is correctly installed, and restart.
(Controllers for FlexRIO only) Your device appears under the Remote Devices section.
4.
Front Panel and Connector Pinouts
The following figure shows the front panel connectors for the NI 5752/5752B.
If you do not see your hardware listed, press <F5> to refresh the list of
NI 5752/5752B Getting Started Guide | © National Instruments | 7
Advertisement
Table of Contents
