Mounting The Wall Bracket - RADEMACHER RolloTron Swivel Winder Standard DuoFern 2510 Translation Of The Original Operating And Assembly Manual

i

10. Mounting the wall bracket

Note for mounting on window frames, etc.
Weak window frames may break.
◆ When mounting on window frames, please check
their structure and load capacity. Especially when
mounting onto designs made of synthetic materials,
the fastening screws must be screwed tight and must
not loosen during operation.
◆ If required, ask your window manufacturer before
fastening the belt winder onto a window frame made
of synthetic materials.
1.
Use the provided mounting holes.
Two mounting holes are required to fasten the belt wind-
er. Generally, it is possible to use the existing mounting
holes of the old belt winder to screw the wall brackets
in place.
2.
Draw on the new mounting holes.
Hold the wall bracket onto the
desired installation position
and draw on both mounting
holes if new mounting holes
need to be drilled.
3.
Drill mounting holes (only required for wall mounting).
Drill the mounting holes with a 6 mm masonry drilling
machine and place the provided wall plugs into the
drilled holes.
EN
71