Table of Contents
Advertisement
Troubleshooting
Problem
No outdoor sensor
reception
no bars
Outdoor
temperature
is flashing or
showing dashes
Inaccurate forecast
• Relocate the display and/or the 3-in-1 sensor.
The units must be within 330 ft (100 m) of each other.
• Make sure both units are placed at least 3 feet (.9 m)
away from electronics that may interfere with the wireless
communication (such as TVs, microwaves, computers, etc).
• Use standard alkaline batteries (or lithium batteries in
sensor when temperature is below -4ºF/-20ºC). Do not use
heavy duty or rechargeable batteries. NOTE: It may take
a few minutes for display and sensor to synchronize after
batteries are replaced.
• Synchronize the units:
1. Bring both the sensor and display indoors and remove
at least one battery from each.
2. Make sure the A-B-C switch on both units match.
3. Reinstall the battery in the outdoor sensor.
4. Reinstall battery into the display.
5. Let the units sit within a couple feet of each other for a
few minutes to gain a strong connection.
Flashing of the outdoor temperature may be an indication of
wireless interference:
• Make sure the A-B-C switch in the battery compartments of
both the display and sensor are switched to the same letter.
You may choose A, B or C; but both units must match to
sync up. Sometimes changing to a different channel
can help.
• Weather Forecast icon predicts conditions for the next
12 to 24 hours, not current conditions.
• Has Learning Mode icon disappeared from the display?
Learning Mode must complete before forecast and pressure
will be accurate.
• Allow unit to run continuously for 33 days. Battery removal
or resetting the display will restart Learning Mode. After
14 days, forecast should be fairly accurate, however
Learning Mode calibrates for a total of 33 days.
13
Possible Solution
Advertisement
Table of Contents
