Table of Contents
Advertisement
Troubleshooting
No outdoor sensor
reception
no bars
Display screen
not working
Outdoor
temperature
is flashing or
showing dashes
Inaccurate
temperature
or humidity
If your AcuRite product does not operate properly after
trying the troubleshooting steps, call (877) 221-1252 or
email info@chaney-inst.com for assistance.
If the wireless signal indicator shows no bars:
• Relocate the display and/or the outdoor sensor. The
units must be within 100 m (330 ft) of each other.
• Make sure both units are placed at least 90 cm
(3 feet) away from electronics that may interfere with
the wireless communication (such as TVs, microwaves,
computers, etc).
• Use standard alkaline batteries. Do not use heavy
duty or rechargeable batteries. NOTE: It may take
a few minutes for display and sensor to synchronize
after batteries are replaced.
• Check that the power adapter is plugged into the
display and an electrical outlet.
Flashing of the outdoor temperature is generally an
indication of wireless interference.
1. Bring both the sensor and display indoors and
remove at least one battery from each.
2. Make sure the A-B-C switch on both units match.
3. Reinstall the batteries in the outdoor sensor.
4. Reinstall the batteries in the display.
5. Let the units sit within a couple feet of each other
for a few minutes to gain a strong connection.
• Make sure both the display and sensor are placed out
of direct sunlight and away from any heat sources or
vents (see page 8).
• Make sure both units are positioned away from
moisture sources (see page 8).
11
Advertisement
Table of Contents
