Care And Maintenance - Goddess RCC 0148 GS9 Instruction Manual

ENg

CARE AND MAINTENANCE

• Periodically clean air vents and the condenser at the rear of the appliance with a vacuum
cleaner or a brush.
• Clean the outside using a soft cloth.
Prolonged disuse
1. Empty the refrigerator.
2. Disconnect the appliance from the power supply.
3. Defrost and clean the interior.
4. In the event of prolonged disuse, leave the door open to prevent the formation of mould,
odours and oxidation.
5. Clean the appliance.
- Clean the inside of the low temperature compartment (where fitted) when defrosting.
- Periodically clean the inside of the refrigerator compartment with a sponge dampened
in warm water and/or neutral detergent. Rinse and dry with a soft cloth. Do not use
abrasive products.
- Clean the outside with a soft damp cloth.
- Do not use abrasive products, scourers, stain-removers (e.g. acetone, trichloroethylene)
or vinegar.
Replacing bulbs:
INSTALLATION
• Install the appliance away from heat sources. Installation in a hot environment, direct
exposure to the sun or installation near heat sources (heaters, radiators, cookers) will
increase power consumption and should therefore be avoided.
• If this is not possible, the following minimum distances must be respected: 30 cm from coal or
paraffin stoves; 3 cm from electric and/or gas stoves.
• Fit the spacers (if supplied) on the rear of the condenser positioned at the back of the
appliance.
• To optimize appliance efficiency, leave a 5 cm gap above the appliance and make sure that
adjacent kitchen units are sufficiently distanced (at least 10 cm on both sides a 7,5 cm from
the wall) to allow air circulation.
• Install the appliance in a dry, well-ventilated place, and ensure it is level, using the front
adjustment feet if necessary.
• Clean the interior.
• Fit the accessories.
When replacing the bulb, proceed as follows:
• Unplug the appliance from the mains
• Squeeze the tabs on the sides of the lamp cover
and remove it.
• Replace the bulb with a new one, maximum 1 W.
• Put the lamp cover back on and wait 5 minutes before
plugging the appliance back into the mains. („Note: this
procedure is valid only for the appliances with standard bulb.
In case of the lighting-failure on appliance with LEDs, pls,
contact authorised service.")
ENG - 25