Correct Operate And Maintenance; Door Reverse - Goddess RSD 083 GW8A Instruction Manual

CORRECT OPERATE AND MAINTENANCE

1. A 10A safety fuse should be installed on the power supply code, and use a single grounded
socket.
2. Don't extent the power code or add other electrical load.
3. Operate the appliance emptily at the first time, turn the temperature knob to "1-4", then the
compressor start operating. Keep operating 30 minutes, put hands both onto the outside and
inside.If hot outside and cool inside, that means the appliance work normally.
4. During operation, turn the temperature to mid position. Turn it to the highest position while
need freeze.
5. Clean the frost when it reach 3-4mm on the evaporator. This series refrigerators are
semi-automatic defrost; need manually press the thermostat knob (as show in the figure).
Renewed automatically when finished. The defrost water will drip into the Drip Tray, so pour
it after defrost and dry the tray and the inside body.
6. Try not to open the door too often.
7. Don't cool bottle bear or drink in the freezer room, to avoid frost cracking or blasting.
8. Do not store flammable, highly volatile and eroded goods.
9. Do not scratch the evaporator by any sharp substance, for that will broke the evaporator.
10. Disconnect the power bar before cleaning the appliance. Use soft cloth to wipe with warm
water or neuter cleaning agent, and then clean it with water.
11. Keep the door gasket clean, on order to maintain well seal.
12. Use soft cloth or soft brush to clean the dust on the compressor and suction tube.Don't wash
it by water.
13. Do not use flammable or strong corrosive cleaning agent to clean the appliance.

DOOR REVERSE

Users can change the direction of opening according to one's own needs. The concrete
operating sequence is as follows:
1. Remove the hole cover.
2. Remove hinge cover and top hinge with a "+" screwdriver, then
remove the door.
ENG - 35
ENG