Magnet Detection - Rotabroach ELEMENT 50 AUTO Manual

Element 50 AUTO Manual
To operate the auto feed function turn on the mag drill
and ensure it is set to the correct speed. With the unit
turned on, push the capstan lever towards the machine.
Once in place, the auto feed is activated and the spindle
will begin to plunge. Once the drilling operation is
completed, the spindle will automatically retract until
the cutter is free from the workpiece and the machine
will turn off.
In the case where the spindle does not retract
completely, deactivate auto feed by pulling the capstan
levers into the manual position and manually retract
the cutter before turning the drill off.
Warning do not operate the auto feed function while
tapping.

11) MAGNET DETECTION

It is advised that when working on thin material a packing piece should be used to increase the
material thickness under the magnet. Working on thin material without a packing piece will reduce
the magnet holding force.
It is advised that the drill is to be operated on ferrous material 12mm thick and above. Damage to
the magnet base, such as pitting, will affect the strength of the magnet holding force.
Original Instructions
12
June 2022