SUPREME Astra 38 Owner's Manual
Hide thumbs Also See for Astra 38:

Advertisement

Quick Links

Astra 38
Owner's Manual
Model Number: 38SFC
This product is proudly developed and manufactured in North America by SUPREME FIREPLACES INC.
3594 Jarry East, Montreal, QC H1Z 2G4
T: 877-593-4722, F: 514-593-4424
www.supremem.com
Revised: October 2018
IMPORTANT: Keep the owner's manual for future use.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Astra 38 and is the answer not in the manual?

Questions and answers

Summary of Contents for SUPREME Astra 38

  • Page 1 Astra 38 Owner’s Manual Model Number: 38SFC This product is proudly developed and manufactured in North America by SUPREME FIREPLACES INC. 3594 Jarry East, Montreal, QC H1Z 2G4 T: 877-593-4722, F: 514-593-4424 www.supremem.com Revised: October 2018 IMPORTANT: Keep the owner’s manual for future use.
  • Page 2: Table Of Contents

    Chimney Sweeping Cap ........................4 Door ..............................4 Certification Label ..........................4 Removable Ash Lip ..........................4 SUPREME Radiation Shield Offset ..................... 4 2.10 Blower Kit ............................5 2.11 Optional Hot Air Kit ..........................5 2.12 Optional Fresh Air Kit .......................... 5 INSTALLATION INSTRUCTIONS ......................
  • Page 3 Chase Installation ..........................13 Clearances to Combustibles ......................14 Blower Kit ............................15 OPTIONS ..............................16 Hot Air Kit ............................16 Fresh Air Kit ............................17 OPERATION INSTRUCTIONS ......................... 18 Fuel ..............................18 First Fires ............................18 Operating the Combustion Air Control ....................18 Starting a Fire ............................
  • Page 4: Safety

    SUPREME FIREPLACES INC. congratulates you on purchasing an Astra 38 wood burning fireplace. This manual describes the installation and operation of the Astra 38 non-catalytic wood heater. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood heaters sold after May 15, 2015.
  • Page 5: General Information

    GENERAL INFORMATION 2.1 Overall Dimensions...
  • Page 6: Specifications

    It is located on the top of the firebox, at the front center of the unit. The combustion air control of the Astra 38 has two components: the Activator and the Burn Rate Selector.
  • Page 7: Cold Hand Key

    2.4 Cold Hand Key The Cold Hand Key is an accessory that comes standard with the Astra 38 fireplace. The Cold Hand Key is a tool used to manipulate the Combustion Air Control Levers when it is hot. 2.5 Chimney Sweeping Cap The chimney sweeping cap found at the baffle of the Astra 38 allows easy access for chimney sweeping without having to remove any components of the firebox.
  • Page 8: Blower Kit

    2.10 Blower Kit A dual AC tangential blower (electrical rating: 115V, 60Hz, and 112W) with a variable speed control is installed into the Astra 38 wood burning fireplace to maximize efficiency. Refer to Section 3.8 for installation instructions. WARNING: Make certain that the fireplace in not in operation and the blower is unplugged (breaker off) before accessing the electrical wiring of the blower kit.
  • Page 9: Installation Instructions

    Figure 3-1: Straight Wall Installation before installing your Astra 38. 3.1 Location Determine the location of the Astra 38 by taking into consideration the following criteria:  The size of the room with respect to the heat output of the fireplace.
  • Page 10: Chimney Installation

    3.2 Chimney Installation The Astra 38 is approved with a 6” chimney that is listed under the UL 103 / ULC S629 standards (refer to Table). WARNING: Mixing chimney components from different brands is a safety hazard and will void the warranty on the unit.
  • Page 11: Listed Ul 103 / Ulc S629 Approved Chimney Models (Reference Table)

    2. For an installation with the chimney running through the ceiling, install the SUPREME Radiation Shield Offset below the chimney opening prior to installing the radiation shield (refer to Figure 2-1, 3-6, & 3-8).
  • Page 12: Offset Installation

    3.2.6 Connecting to a Masonry Chimney The Astra 38 fireplace can be connected to a masonry chimney that complies with current national and municipal building codes. A 6” chimney liner that complies with ULC S635 M2000 (Canada) or UL 1777 (US) standards must be installed within the existing masonry chimney.
  • Page 13 The installation of the prefabricated chimney and the liner must comply with the manufacturer’s instructions. The following are instructions in installing the venting of the Astra 38 running through a masonry chimney: 1. Install the anchor plate onto the unit.
  • Page 14: Façade Installation

    3.3 Façade Installation The Astra 38 can be installed with either the traditional façade or the contemporary façade. 3.3.1 Traditional Façade The traditional façade comprises louvers below (intake) and above (outtake) the door. All components and fasteners are included in the façade kit.
  • Page 15: Contemporary Façade - Single Linear Front Louver

    14. From the exterior of the chase, fasten the grills over the intake and outtake openings with the provided screws. 3.4 Framing The Astra 38 can be placed directly onto or against normal, combustible construction materials such as lumber, plywood, millboard, particleboard, drywall and decorative wood paneling.
  • Page 16: Hearth Extension

    3.5 Hearth Extension The hearth extension of the Astra 38 must comprise of a non- combustible material, such as steel, cement or mortar, bricks, or ceramic tiles. Note that unidentified materials may be combustible; verify product specifications prior to installation. The hearth extension must extend a minimum of 18”...
  • Page 17: Clearances To Combustibles

    Outer edge of fuel door 84” (214 mm) Base of unit Ceiling Table 3-2: Mantel Clearances Distance from the Base of Maximum the Astra 38 to the Bottom of Mantle Depth the Mantle 3” (7.6 mm) 51.5” (130.8 mm) 5” (12.7 mm) 53.5”...
  • Page 18: Blower Kit

    85°F. The speed of the fans can be adjusted with the variable speed control (rheostat) mounted on the wall. It is safe to operate the Astra 38 in the event of a power failure (fans not powered). Figure 3-16: Electrical Diagram...
  • Page 19: Options

    OPTIONS 4.1 Hot Air Kit The hot air system is an optional kit intended to bring hot air from the fireplace to a remote area using a 250 CFM blower. The system is designed to distribute heat with ducting lengths up to 25’. Note that only an insulated flexible duct capable of withstanding a maximum temperature of 210 F can be installed with this kit.
  • Page 20: Fresh Air Kit

     Use the SUPREME FIREPLACES INC. Fresh Air Adaptor (ADP4)  Use the SUPREME FIREPLACES INC. Fresh Air Kit (UPEA4) or any other fresh air kit with the same specifications and intended for fireplace use. Installation: 1. Cut 4 ½” diameter hole on the exterior wall of an ideal location.
  • Page 21: Operation Instructions

    Due to oil residues and the curing of the paint of the fireplace, it is normal to smell an odor for the first fires of the Astra 38. Open a window or a door near the fireplace to ventilate the house during the first fires.
  • Page 22: Starting A Fire

    5.4 Starting a Fire The Astra 38 has patented technologies and innovative features that make starting a fire quick and easy. Before starting a fire, assure that all the safety precautions mentioned in the owner’s manual are being respected.
  • Page 23: Adding A New Load Of Wood

    Once the embers begin to glow red, add the new load of wood in the firebox. e) Keep the door of the Astra 38 slightly unlatched until you see a flame in the firebox. Never leave the Astra 38 door unlatched without constant supervision.
  • Page 24: Troubleshooting

    Draft is the force created by a difference in pressure, which moves air from the appliance up through the chimney. It is important to operate the Astra 38 with proper draft to ensure optimal performance of the unit. Draft is depended on the length of the chimney, local geography, nearby obstructions and other factors. Proper draft results in an upwards flow through chimney, which prevents smoke infiltrating into the house during operation of the unit.
  • Page 25: Maintenance

    (if needed) by a qualified technician. NOTE: Do not clean the chimney when the unit is in operation/hot. Follow the instructions below for sweeping the chimney of an Astra 38 fireplace: a) Open the door of the unit.
  • Page 26: Cleaning Of Glass

    WARNING: Do not operate the unit with any of the cast iron panels missing. 7.5 Replacement of Door Gasket SUPREME FIREPLACES INC. assembles heat resistant graphite coated gaskets on the doors of all products, allowing for a proper seal of the unit at extreme temperatures (up to 1000 F).
  • Page 27: Replacement Of Glass

    CAUTION: Wear protective gloves when handling broken glass. Refer to the following instructions for replacing the glass: a) Order the replacement kit for the Astra 38 glass. b) Remove, clean, and dispose any broken glass from the door and the surroundings.
  • Page 28: Paint

    7.8 Paint Paint touch-ups can be performed on the unit using a high temperature paint (in aerosol spray can format) by Stove Bright®. Refer to your invoice to determine the precise color of your unit. Contact your local hearth shop for further information on purchasing this paint.
  • Page 29 PA5000 Combustion Air Control (specify color) CM0020 Cold Hand Key CPSP0301 Removable Ashlip (specify color) Cast Iron Panel 32SF1175 16” X 12.625” X 1.25”...
  • Page 30: Warranty

    EXCLUSIONS: SUPREME FIREPLACES INC. shall not be responsible for any labor costs for the replacement or repair of any electrical components, painted/plated parts, secondary air burning system, and the combustion air control. The following parts are guaranteed for 1 year: blowers, painted/plated parts, secondary air burning system, and door gasket.
  • Page 31 In the case of a return for repair or replacement, it is the responsibility of the customer to adequately package the component/unit to prevent further damage during transport. Items sent to the SUPREME FIREPLACES INC. without an open warranty claim will be returned to the sender. Warranty claims should be addressed to: SUPREME FIREPLACES INC.

This manual is also suitable for:

Astra 38cfAstra 38td

Table of Contents